Antari S-500 Mode D'emploi page 12

IMPORTANT NOTE:
[LEFT BUTTON] is meant for priming use, with a new tank of fluid or refill the fluid may not
pump properly due to airlock in the pipeline, use this function to activate pump at maximum
output, the [RIGHT BUTTON] is used when needed to clean out residue at the tip of output
nozzle. Both of these buttons will overtake output adjustment knobs.
Physical Installation

Use supplied mounting bracket or rigging clamp to install nozzle.

Make sure installation location, fastening connecting, and rigging hardware can hold at
least 10 times the weight of the nozzle.

Make sure no combustible or flammable materials are nearby.

Secure nozzle with an approved safety cable that can hold at least 10 times the weight
of nozzle.

Make sure nozzle is installed in a well ventilated area.

Consider nozzle replacement and routine maintenance access when selecting
installation location.
Adjustable Mouting Bracket
Adjust mounting bracket by loosening screws, set the nozzle to desired angle and tighten
the screw to finish adjustment. Illustration below demostrates how to adjust mounting
bracket.
Important
12