Antari S-500 Mode D'emploi page 6

Setting Up
Step 1: Place the machine on a flat surface and in a suitably large area with at least 50 cm
open space around the machine.
Step 2: Fill the fluid tank with Antari approved fluid.
Step 3: Connect the machine to a suitably rated power supply. To determine the power
requirement for the machine refer to the label on the back of the machine.
Always connect the machine to a protected circuit and ensure it is properly
grounded to avoid risk of electrocution.
Step 4: Turn on the machine, press the [VOLUME]/[DOWN] button on the control panel to
XLR 3-Pin DMX Connector
PM-1 Pan Motor (Optional)
6
XLR 5-Pin DMX Connector
Neutrik PowerCon
SC-3 Remote Control (Optional)