Conrad 64 63 68 Notice D'emploi page 55

• "PRESSURE UNIT" (setting the air pressure unit): With the arrow buttons "
the air pressure unit: "hPa" (Hectopascal), "inHg" (inch mercury column) or "mmHg" (millimetres mercury column).
Confirm the setting with the button "
• "LOCAL ALTITUDE" (setting the altitude for air pressure conversion) With the arrow buttons "
(6), you can select the altitude unit: "Meter" or "Foot".
Confirm the setting with the button "
Set the altitude with the arrow buttons "
This is required to be able to convert the air pressure values for a correct display.
The air pressure details which you obtain e.g. via the radio, TV and the Internet usually refer to sea level.
Confirm the setting with the button "
• "SLIDESHOW DURATION" (break duration for slideshow): With the arrow buttons "
set the duration for the slideshow, meaning how long each image is displayed.
Confirm the setting with the button "
• "RCC UPDATE" (manual search for DCF signal): With the arrow buttons "
between "No" and "Reboot after 10mins".
With "Reboot after 10mins" and pressing the button "
The display of the weather station is turned off for 10 minutes to enable reception of the DCF signal. The reception
attempt is cancelled by pressing any button.
In the display "CLOCK" and "INFO BOARD", a radio tower icon later on indicates whether the DCF reception was
successful or not (icon " " or icon " ", see chapter 10. b).
• "COUNTRY" (country for displaying the sun/moon rise/set times): With the arrow buttons "
select the desired country.
Confirm the setting with the button "
• "CITY" (city for displaying the sun/moon rise/set times): With the arrow buttons "
closest to your location.
Confirm the setting with the button "

Regretfully, it is not possible to save the degrees longitude/latitude for many thousands of places in the
weather station. Please select a place closest to your location.
The values for the rise/set times of sun and moon calculated by the weather station may therefore
deviate by a few minutes from the actual time.
" (9), or press the button "
" (9) to access the setting for the altitude.
" (5) and " " (6). The altitude is the approximate altitude of your location.
" (9), or press the button "
" (9), or press the button "
" (9), the display changes to:
" (9), or press the button "
" (9), or press the button "
" (5) and " " (6), you can select
" (2) to cancel.
" (5) and "
" (2) to cancel.
" (5) and " " (6), you can
" (2) to cancel.
" (5) and " " (6), you can switch
" (5) and "
" (2) to cancel.
" (5) and " " (6), select a place
" (2) to cancel.
"
" (6),
57