Replacing The Light Bulbs - Dacor Heritage HWO127 Manuel De L'utilisateur

Clean the door gasket with extreme caution to avoid compromising
the seal required for proper cooking and self-cleaning.
Clean the door gasket by dabbing it with a solution of water and
mild soap. Do not scrub it or it will become damaged.
Cleaning the Oven Racks
Do not self-clean the oven racks.
‣ Apply a hot-water and detergent solution. For heavy soil, use a
scouring pad with ample water. (Instead of water, you may use a
solution of 1 cup of ammonia to 2 gallons of water.)
Cleaning the Meat-Temperature Probe
• Do not immerse the meat probe in water.
• To ensure proper function, dry the probe's plug completely before
connecting it to the oven.
The meat probe has silicone handles, a wire, a plug and a stain-
less-steel skewer.
1. Clean the skewer with a scouring pad and hot, soapy water.
2. Wipe thehandles with a soft sponge soaked with a solution of
detergent and warm water.
3. Dry all surfaces thoroughly with a clean, soft cloth.

Replacing the Light Bulbs

This task can be done by the owner. If none of the lights work,
before replacing them, consult Troubleshooting, Pg. 17.
• To prevent an electric shock hazard and personal injury, turn off
power to the oven, and ensure the oven and bulbs are cool.
• Only use the oven with the lens covers installed. The covers protect
the bulbs from high temp's and mechanical shock.
• Replacing the lens cover without lining up the cutout with the light
socket will damage the light fixture.
• Do not use a screwdriver to remove the lens.
IMPORTANT
Do not touch the replacement halogen bulbs with your fingers. Oils
from your hand make the bulbs burn out faster than normal.
1. Replace the light bulb only with Dacor bulb PN 100429, 12V 20W.
(Visit www.everythingdacor.com for ordering information.)
2. Turn off power to the oven at the circuit breaker/fuse box.
3. Supporting the lens from below, gently pry it loose with a table
knife, and pull the lens cover straight out.
4. Pull the old bulb straight out of the socket.
5. Wearing a glove, take the new bulb, and insert it in the socket.
6. Align the lens cover cutout with the light socket, and gently
press the cover into place.
CARE AND CLEANING
CAUTION
CAUTION
WARNING
7. Return power to the
oven, and reset the
clock (pg. 4).
13
Light
socket
Light bulb
Cutout on
inside rim of
lens