Lubrication; Ordering Spare Parts; Disposal And Environmental Protection - Greifzug blocstop BSO Série Manuel D'installation

Installation and operating manual

Lubrication

DANGER!
Danger of falling caused by a slippery safety rope!
May result in severe injuries or death!
– Never lubricate the safety rope using a lubricant that
contains disulfide (e.g. Molycote
– Use multi-purpose grease or oil.
– Cleaning the rope or the independent secondary brake
with high pressure cleaners is prohibited! Penetrating
moisture will result in malfunctions and damage.
– Dirt on the wire rope results in premature wear or the
destruction of the rope, rigging and independent secon-
dary brake.
Replacement
Replace the ropes immediately if the withdrawal criteria in accor-
dance with Table 3 have been reached (as per ISO 4309 and
DIN 15020, Sheet 2) or typical rope defects are present, see
Fig. 7.
Design of the rope
4 x 26 4 x 36
[mm] Number of visible broken wires in the outer strands
over a length of 30 x rope's nominal diameter.
6
8 10 10
9 10 10
10 8
11,5 10
14 10
16 13
Table 3
Implementation: See '14 Dismantling'
'10.3 Assembly' on page 9.
Renewing rope tips
Send the rope to Greifzug Hebezeugbau GmbH or an lifting
equipment service company authorised by Greifzug Hebezeug-
bau GmbH and have the tip replaced.
EN-16
).
®
5 x 19 5 x 26 5 x 31
[mm]
8 5,9
8 11 7,5
8 8,5
11 9,3
11 10,5
11 13,1
13 15,0
on page 14 and

16.4 Ordering spare parts

Spare parts lists can be requested from your supplier or directly
from Greifzug Hebezeugbau GmbH.
The details needed to place the order are listed on the separate
component's nameplates, see 'Nameplate and warning signs /
application restrictions' on page 6.
The required information is e.g.:
Independent Article no., model
secondary brake:
17 Disposal and environmental
protection
The equipment is made from recyclable materials. If the equip-
ment is later scrapped, it must be disposed off correctly. The
national versions of the waste legislation directive 75/442/EEC
apply within the European Union (in Germany Kreislauf-
wirtschafts- und Abfallgesetz (KrWAbfG)).
The manufacturer is obliged to take back and dispose of specific
electrical and electronic components in accordance with Directive
2002/96/EC. The following symbol is used on the nameplate of
such components to identify them:
G905.5 - 02/2011