Ropes; Optional Accessories; Options; Model Versions - Greifzug blocstop BSO Série Manuel D'installation

Installation and operating manual
5

Ropes

General
DANGER!
Incorrect rope or rope with incorrect diameter!
Using an incorrect rope leads to a danger of falling or injury
through falling objects and the risk of malfunctions!
– In order to operate safely only use original ropes author-
ized by Greifzug Hebezeugbau GmbH with the correct
rope diameter and the required design.
The required rope diameter is listed in Table 1 on page II.
The design is listed in Table 3 on page 16.
Alternative wire rope assemblies:
End/thimble
End/safety hook
6

Optional accessories

Anchoring options e. g. fishplate sets
7

Options

The independent secondary brake models described here are
can also be supplied with an optional limit switch fitted to them
(e.g. blocstop™ BSO 2030 E).
Please contact Greifzug Hebezeugbau GmbH directly.
8

Model versions

The standard stopping speed of the independent secondary
brakes described here is 30 m/min. Models with stopping speeds
of 20, 40, 60 and 70 m/min can also be supplied if requested.
9

Necessary accessories

The following accessories, which are not part of scope of delivery,
are necessary to use the product:
Original Tractel rope
®
Clamp (weights) for the rope, see Fig. 6
The operator or the manufacturer of the system is responsible for
selecting and using the accessories in accordance with the local
conditions. You must also abide by any other requirements of the
respectively applicable regulations and standards.
EN-8
10

Installation and commissioning

10.1 Directives and standards

The independent secondary brake fulfils the following directives
and standards:
Machine Directive 2006/42/EC
DIN EN ISO 12100
Machines for lifting personnel or personnel and materials
(transport of persons):
EN 1808:1999 + A1:2010
The following are also applicable for independent secondary
brakes fitted with limit switches:
The safety goals required by Directive 2006/95/EC have
been complied with in accordance with Appendix I No. 1.5 of
the Directive 2006/42/EC.
The operator or the system manufacturer is responsible for en-
suring that the machine is used within the limits specified in these
instructions. The operator or the system manufacturer must also
observe the directives and standards and EN ISO 14121 and EN
ISO 13849 for the machine in which the unit will be fitted.
10.2 Checks to be undertaken before
starting installation
Checking the suspended assembly
The suspended assembly for the ropes and products must com-
ply with the Directive 2006/42/EC and the applicable standards
(such as EN 1808).
Observe the details in 'Structural requirements' on page 6.
Inspecting the installation site
– Check whether the device can be installed correctly without
it being obstructed by other components.
The installation space must not contain any sharp or edged
components.
– Check that the mounting does not cover any nameplates
(see Fig. 4).
– The independent secondary brake must be secured in place
so that the rope runs vertically into the independent secon-
dary brake from above. The independent secondary brake
must be aligned so that it does not touch the rope. The rope
must be tensioned using a tensioning weight or a relevant
winding device.
– The independent secondary brake must be mounted so that
the operator can trigger the EMERGENCY-STOP at any
time and can check the function via the inspection window.
Installation examples: When using personnel lifting equip-
ment e. g. on a working platform; when using material lifting
equipment e. g. at the operator's site.
G905.5 - 02/2011