Storage; Maintenance Work; Authorized Maintenance Personnel; Mandatory Inspections - Greifzug blocstop BSO Série Manuel D'installation

15.2 Storage

General storage conditions
Dry location (maximum of 75% relative humidity)
Dust-free
Even ambient temperature
Wire rope storage conditions:
Lightly greased
Avoid contact with chemicals (e.g. battery acid).
Store without any mechanical crushing, pressure or tensile
stress.
16

Maintenance work

16.1 Authorized maintenance personnel

DANGER!
Risk of falling! Risk of being injured by falling objects!
Danger of death due to incorrectly carried out maintenance or
service work!
Maintenance and service work which requires the product to
be opened may only be performed by the following authorized
parties:
– The Greifzug Hebezeugbau GmbH
– Lifting equipment service companies authorized by
Greifzug Hebezeugbau GmbH
– Service personnel trained and certified by Greifzug He-
bezeugbau GmbH

16.2 Mandatory inspections

A written certificate is required for the annual safety inspection
and any exceptional tests. The inspections must be recorded in
the logbook included with delivery.
Prior to every use
Always check to ensure that the device is in an orderly working
condition before use, see '10.4 Commissioning' on page 10.
Annual safety inspection
The safety inspection must be carried out annually.
The safety inspection may only be undertaken by authorised
maintenance personnel, see '16.1 Authorized maintenance per-
sonnel' on page 15. Depending on the usage conditions (e.g.
operation in an extremely dirty environment), an intermediate
inspection may be necessary.
We recommend that the system is tested in our factory by
Greifzug Hebezeugbau GmbH.
G905.5 - 02/2011
Contact Greifzug Hebezeugbau GmbH or your supplier with
regards to this test.
Exceptional tests
The independent secondary brake must be inspected by
Greifzug Hebezeugbau GmbH or an authorised hoisting gear
workshop.
See '12.3 Measures to be taken after a problem or an emer-
gency-stop' on page 13.

16.3 Care and maintenance

Interval Work
Weekly
– Lubricate the safety rope
– Clean the independent
secondary brake housing
1 x annu-
– Inspect for clamping jaw
ally /
wear
every 250
– Check for pressure / drive
operating
roller wear
hours of
the hoist
Whenever
– Replace the clamping jaws
necessary
– Replace the pressure / drive
rollers
– Replace the safety rope
Rope
DANGER!
Risk of injury through stabs and cuts!
Broken wires in the wire rope can result in protruding wires!
Protruding wires can cut or stab through safety gloves!
– Wear suitable leather protective gloves when working
with wire ropes.
– Never let the wire rope run through your hands!
Cleaning
Brush the dirt off soiled ropes when dry if necessary. Re-lubricate
as necessary.
Installation and operating manual
Implementation
Operating personnel
Authorised mainte-
nance personnel
Authorised mainte-
nance personnel
Trained person nomi-
nated by the operator
EN-15