Table des Matières
Publicité
Inserting the battery
Open the battery/SD card slot cover (
Battery/SD card slot
cover
1 AAA LR03 battery (not supplied)
Make sure the battery faces the
right direction.
Close the battery/SD card
slot cover (
●
Use an alkaline battery.
●
Remove the battery from the unit if you will not use it
for a long period of time.
and
)
1
2
and
)
4
5
The remaining battery level is displayed as below
while this unit is operating.
●
If the battery runs out, "
battery as soon as possible.
●
When the battery runs out of power, "
indicated and then the power turns off automatically.
●
Depending on the battery status or the operation
content to use, even if the power turns off due to the
battery exhaustion, this unit may be used for a while if
turned on again. However, the unit may suddenly turn
off during operation due to the low level of battery.
●
Some level of battery is required when performing
deleting files, formatting ( ➜ page 14), and dividing
files ( ➜ page 27). If the battery indicator shows "
(blinking) and these operations are performed, the
power turns OFF due to the battery exhaustion.
●
Make sure to turn the power off before removing
the battery.
• If the battery is removed while the unit is on, data
may be lost or this unit may be damaged.
Set the clock after inserting a battery for the first time
or replacing the battery. ( ➜ page 9)
Blinking
" blinks. Replace the
" is
"
7
7
Publicité
Table des Matières
