Table des Matières
Publicité
Changing the playback speed A-B Repeat play
The playback speed can be adjusted in 21 steps from
the slow speed of 0.5 times normal speed (50%) to
the fast speed of 2 times normal speed (200%).
1
2
3
●
●
20
20
Press [q OK] while playing.
Press u, i to adjust the
playback speed.
Playback speed
• i: Each press of this button increases
the playback speed.
• u: Each press of this button reduces the
playback speed.
The playback speed can be adjusted in 10%
steps for speeds faster than normal speed
(100%), and 5% steps for speeds slower
than normal speed (100%).
• Press [STOP g/RETURN] to return to
normal speed (100%).
Press [q OK].
The setting value is confirmed.
Normal playback may not be possible
depending on the file.
If you change the playback speed, NOISE
CANCEL will not work. (➜ page 23)
Playback repeats between the start point (A)
and finish point (B) if those points are set.
• Set the shadowing function to OFF.
1
( ➜ page 21, steps
to
Press
1
[ERASE/A-B&]
while playing.
The start point (A) is
set and "
" (lighting)
and " " (blinking) are
displayed.
Press
2
[ERASE/A-B&] at
the finish point (B).
The display changes to
"
" (lighting) and
repeat play starts.
Cancelling A-B Repeat:
Press [ERASE/A-B&] again. (A-B Repeat can also
be cancelled with [STOP g/RETURN], u or i.)
●
You cannot set A-B Repeat when the time
between the start point (A) and finish point (B)
is approx. 2 seconds or less.
●
When only the start point (A) is set and playback
continues until the end of the file, the end becomes
the finish point (B) and A-B Repeat begins.
●
A-B Repeat by setting the range using 2 files
is not possible.
3
)
A-B Repeat indication
Publicité
Table des Matières
