Transportation And Storage; General Information; Disassembling The Lift - Invacare ISA Série Manuel D'utilisation

7 Transportation and Storage

7.1 General information

During transportation, or when the patient lift is not to be
used for some time, the emergency stop button should be
pushed in.
A disassembled lift can be located in the packaging box, for
transportation and storage.
The patient lift must be stored at normal room temperature.
If it is stored in a damp, cold or wet environment then the
motor and other mounting parts may be prone to corrosion.
See 11.4 Environmental conditions, page 28.
1654371-A

7.2 Disassembling the lift

1. Remove the leg spreader lever if attached.
2. Lower the boom and close the legs completely.
3. Activate the emergency stop button and apply castor
brakes.
4. Adjust the lifting arm to minimum length. See 5.5
Adjusting the lifting arm to patient body height, page 13.
5. Reverse the procedure described in 4.6 Installing the
leg support, page 11.
6. Reverse the procedure described in 4.3 Installing the
mast to the base, page 10.
7. Reverse the procedure described in 4.4 Installing the
foot plate, page 11.
Transportation and Storage
21