Programming The Speed Controller - GAUI X5 3D Notice D'emploi

Programming the Speed Controller

1. Call programming mode
• Switch on the transmitter and move the throttle control lever to the full throttle position.
• Connect the rechargeable battery to the speed controller. The motor connected to the controller emits 3 brief sounds
with increasing pitch and two brief sounds after two seconds.
• After another 5 seconds, the connected motor emits 5 brief sounds with increasing pitch.
• The controller is now in programming mode.
2. Call menu item
• In programming mode, you will now hear 14 groups of different signals that are continually repeated in a loop. The
red LED flashes at the same rhythm. Assignment of the respective signal sounds to the menu items can be taken
from the following table.
No. Sound sequence
1 1 x brief
2 2 x brief
3 3 x brief
4 4 x brief
5 1 x long
6 1 x long, 1 x brief
7 1 x long, 2 x brief
8 1 x long, 3 x brief
9 1 x long, 4 x brief
10 2 x long
11 2 x long, 1 x brief
12 2 x long, 2 x brief
13 3 x long, 1 x brief
14 3 x long, 2 x brief
• To call a specific menu item, slide the throttle control lever to the bottom-most position (motor off) within 3 seconds
of the respective sound signal.
• The speed controller thus switches to setting mode for the menu item called.
56
Menu item or function
Braking
Battery type
Cut-off mode
Cut-off switching threshold
Start mode
Timing
Governor mode
Unused menu item 1
Clock signal
BEC voltage
Unused menu item 2
LiPo cells
Call default settings
Exit programming mode