GAUI X5 3D Notice D'emploi page 43

Page P.18
Upper figure:
The figure shows the nod trimming function. Set the nod trimming so that the model helicopter hovers stably in hover flight
and does not try to drift away to the front or back all the time. After landing, adjust the subtrimming or swash plate linkage
to set the trimming lever back to the centre position with the helicopter still hovering stably.
Lower figure:
The figure shows the roll trimming function. Set the roll trimming so that the model helicopter hovers stably in hover flight
and does not try to drift away to the right or left all the time. After landing, adjust the subtrimming or swash plate linkage
to set the trimming lever back to the centre position with the helicopter still hovering stably.
Page P.19 – P.21
Pages 19 to 21 hold spare parts designations and spare parts numbers.
Attention!
Please observe that the 6-digit numbers in the manufacturer's manual are no Conrad order numbers!
For the current list of spare parts with the corresponding Conrad Electronic order numbers, see www.conrad.com
in the download area of the respective model helicopters.
43