Directing The Robot Vacuum Cleaner To The Base Station - Miele RX1 - 4814 Mode D'emploi

^ Press and hold one of the direction
buttons.
The robot vacuum cleaner will travel in
the desired direction without vacuuming.
You cannot direct the robot vacuum
cleaner manually to the base station
in order to recharge it.
Directing the robot vacuum cleaner
to the base station
^ Press the Base button on the remote
control.
The robot vacuum cleaner will travel to
the base station and recharge. The base
station contact indicator will go out.
Finishing vacuuming manually
^ Press the Power button on the
remote control.
The robot vacuum cleaner will switch to
standby automatically after approx.
60 seconds. The display will be
deactivated. The battery capacity
status indicator will continue to light up.
You can switch the robot vacuum
cleaner to standby before 60 seconds
is up by pressing the Power button
again.
You can reactivate the robot vacuum
cleaner by pressing any button on the
remote control or one of the two sensors
in the robot vacuum cleaner display.
Vacuuming modes
There are four different vacuuming
modes.
Auto Standard vacuuming mode for
vacuuming normally soiled
flooring.
Spot For targeted vacuuming of a
surface approx. 5' 11" x 5' 11"
(1.8 m x 1.8 m) around the
selected starting point of the
robot vacuum cleaner.
Corner For vacuuming normally soiled
flooring (see Auto).
Additional edge vacuuming
after returning to the starting
point.
Turbo For vacuuming lightly soiled
flooring with a short vacuuming
duration.
Selecting the vacuuming mode
^ Press the Power button on the
remote control.
There are two ways of selecting the
vacuuming mode.
en
15