Miele RX1 - 4814 Mode D'emploi page 14

en
Starting vacuuming
There are two ways to start vacuuming
in the Auto standard vacuuming mode.
Option 1 (Remote control)
^ Press the ~ II button.
Option 2 (Display)
^ Press the ~ II sensor in the display.
The room to be vacuumed will be
cleaned.
Finishing vacuuming
– if vacuuming started from the base
station
The robot vacuum cleaner will return to
the base station automatically and
recharge.
The robot vacuum cleaner will also
return to the base station and
recharge when there is low battery
capacity.
II will appear in the clock display.
The robot vacuum cleaner will then
continue vacuuming from the point at
which it was interrupted.
– if vacuuming started from
somewhere in the room
The robot vacuum cleaner will return to
its starting point and switch to standby.
14
The robot vacuum cleaner will stand
still when there is low battery capacity.
You should then recharge it.
Manually controlled vacuuming
You can use the direction buttons on
the remote control to vacuum a
particular area of the room.
^ While the robot vacuum cleaner is
vacuuming, press and hold one of
the direction buttons.
The robot vacuum cleaner will turn in
the desired direction.
^ Press and hold the + direction button.
The robot vacuum cleaner will travel in
the desired direction and continue to
vacuum.
Interrupting vacuuming
^ Press the ~ II button on the remote
control.
Press the button again to continue
vacuuming.
Manual navigation (without
vacuuming)
You can use the direction buttons on
the remote control to direct the robot
vacuum cleaner to a specific area of
the room.