Fault Messages - Miele RX1 - 4814 Mode D'emploi

en
The cleaning result is poor.
The dust box is full. Empty and clean
the dust box.
The roller brush is dirty. Clean it.
The dust box seal is dirty. Clean it.
The exhaust filter is dirty. Replace it.
The roller brush has worn out. Replace
it.
The dust box seal has worn out.
Replace it.
The side brushes have worn out.
Replace them.
The robot vacuum cleaner is not
charging.
The base station / robot vacuum
cleaner is not connected to the
electricity supply correctly. Connect the
base station exactly as described in
these operating instructions. Do the
same for the robot vacuum cleaner, see
"Preparing for use - Charge the
rechargeable battery").
The robot vacuum cleaner does not
return to the base station after
vacuuming.
The Auto standard vacuuming mode
was started somewhere else in the
room. The robot vacuum cleaner will
return to its starting point.
When the Spot vacuuming mode is
selected the robot vacuum cleaner
returns to its starting point.
24
There is insufficient light for the robot
vacuum cleaner to navigate - provide
sufficient lighting.
The base station is not connected
correctly. Connect the base station
exactly as described in these operating
instructions.
The sensors on the robot vacuum
cleaner are dirty. Clean them carefully
using a dry cotton wool bud.
The connection from the infrared
transmitter on the base station to the
vacuum cleaner is broken. Clean both
parts carefully with a soft, dry cloth and
make sure that no items disrupt the
connection.
Obstacles on the floor which is to be
vacuumed can impede navigation.
Watch the robot vacuum cleaner during
vacuuming to identify and remove any
problematic obstacles, define the area
they are in with the magnetic strip or
reduce the maximum crossing over
height, see "Use - Reducing the
maximum crossing over height".

Fault messages

,
Before resolving any faults with
the robot vacuum cleaner, switch it
off with the OFF switch on the side.
Fault messages are shown in the clock
indicator of the robot vacuum cleaner's
display.
F 1 "Wheel raised" fault
Place the robot vacuum cleaner
on a level floor surface.