After Sales Service; Warranty; Electrical Connection Au, Nz - Miele RX1 - 4814 Mode D'emploi

F 2 "Dirty sensors" fault
Clean the sensors.
This fault message will also
appear if the side brushes are not
fitted. In this case, fit the side
brushes.
F 3 "Dust box" fault
Insert the dust box into the robot
vacuum cleaner making sure it
clicks into position.
F 4 "Drive wheels overloaded" fault
Check whether the drive wheels
have become dirty.
Remove any threads and hairs.
F 5 "Brushes overloaded" fault
Check whether the roller brush
and the side brushes have
become dirty. Clean the roller
brush and the side brushes.
F 6 "Motor overloaded" fault
Empty and clean the dust box.
Replace the exhaust filter.
F 7 Internal system fault
Switch the robot vacuum cleaner
off and then back on again (press
the ON/OFF switch on the side).
F 8 "Front wheel dirty" fault
Check the front wheel for debris.
Remove any threads and hair and
clean the front wheel.

After sales service

In the event of a fault that you cannot
easily remedy, please contact
– your Miele Dealer
or
– Miele (see back of manual for
contact details)

Warranty

For information on the appliance
warranty specific to your country please
contact Miele. See back of manual for
contact details.
The battery pack must be removed
before disposal. Battery packs may be
considered hazardous waste by your
local municipality. Please dispose of
them responsibly and in accordance
with your local recycling program.

Electrical connection AU, NZ

All work should be carried out by a
suitably qualified and competent
person in strict accordance with
national and local safety regulations.
The voltage and rated load are given
on the data plate located underneath
the vacuum cleaner. Please ensure that
these match the household mains
supply. The fuse rating is quoted on the
plug.
The appliance is supplied with a cable
and moulded plug ready for connection
to a 230 V / 50 Hz AC single phase
supply.
Test Marks
Electrically suppressed according to
en
Electrical safety
RCM Mark
AS/NZS CISPR 14
25