Warning And Safety Instructions - DENTAURUM Orthocryl Mode D'emploi

4. Curing / Polymerization time
Pressure pot: 2.2 bar / 32 psi
Temperature: 40 - 46 °C / 104 - 114.8 ° F
Time: No less than 15 minutes (Orthocryl
No less than 20 minutes (Orthocryl
Polymerisation in a pressure vessel should not be interrupted
during the first 8 minutes (Orthocryl
(Orthocryl ) in order to prevent micro porosity from occurring.
®
Please observe the directions for use and safety
instructions of the pressure pot!
5. Finishing and polishing
Orthocryl acrylics can be finished and polished using
®
conventional acrylic burs and polishers. Please observe the
stipulated protective equipment which must be worn
(facial protection / protective eyewear) during processing.
6. Reducing the remaining monomer content and
the biocompatibility of Orthocryl
In order to reduce the remaining monomer content, the
finished appliance – if possible – should be immersed in water
for three days, before transferring to the patient. This
immersion in water causes the monomer residues to reduce to
values similar to heat-curing resins. If this is not possible, then it
is recommended that the patient places the appliance in water,
during the time it is not worn. Orthocryl
scientifically tested.
Information on this, a comprehensive instruction manual with
many practical tips and the entire product range of Orthocryl
is available for your use.
14
EQ)!
®
)!
®
EQ) or 10 minutes
®
acrylics
®
acrylics have been
®
®
➞ „Beitrag zur biologischen Beurteilung kieferorthopädischer
Kunststoffe" in Fortschritte der Kieferorthopädie 2000, 61,
246-257 (Nr. 4). [(„Biological evaluation of orthodontic
acrylics" excerpt from Fortschritte der Kieferorthopädie
2000, 61, 246-257 (N° 4)].
7. Instructions for cleaning and disinfection
Orthocryl acrylics should be cleaned with tooth paste
®
and brush. Orthocryl acrylics can be disinfected with all
®
commercially available disinfectants for impression materials
(e.g. Impresept / 3M Espe, MD520 / Dürr Dental, Dentavon
®
Schülke+Mayr or Mucalgin / Merz Hygiene).
®
Please observe the instructions by the respective manufacturer.
8. Information on the constituents
Monomer = Methyl methacrylate „MMA" (liquid)
Polymer = Polymethyl methacrylate „PMMA" (powder)
Please observe the safety data sheet which every new customer
automatically receives on first time use and which is available
upon request!

9. Warning and safety instructions

Danger contains methyl methacrylate and ethylene dimethacrylate
Causes skin irritation.
May cause an allergic skin reaction.
Causes serious eye irritation.
May cause respiratory irritation.
Keep away from heat / sparks / open flames / hot surfaces. - No
smoking.
Wear protective gloves / protective clothing / eye protection / face
protection.
/
®
15