power2max Type S Guide De L'utilisateur page 39

Pairing is generally only required once. If you
are installing multiple systems on different
bikes concurrently, you should conduct
pairing successively to avoid undesired
pairing of different power2max
and bike computers.
You can repeat the pairing operation between
your power2max
compatible bike computer at any time. To
do so you need to activate your
powermeter by turning the cranks. Your
power2max powermeter signals its readiness
with a single flash of the green LED.
3. Close the battery compartment again and
tighten the screws to 0.15NM. Make sure the
battery cover is clean and correctly seated.
IMPORTANT: The maximum torque of
the battery cover screws is 0.15NM. This
corresponds to tightening with 2 fingers.
Further tightening is NOT required and
can damage the battery cover or the
powermeter.
38
powermeters
powermeter and your
power2max