power2max Type S Guide De L'utilisateur page 26

4. Install the crankset on your bike
(see also page 36)
power2max
Install the
bike.
Follow manufacturer instructions and
recommended bolt torque!
After installing the crank set check the
operation of the front derailleur and adjust
as required.
5. Install the battery and pair your
powermeter with your ANT+ compatible bike
computer (see also page 37)
Insert a CR2450 battery with the positive
terminal (the side with the writing on it)
facing inward.
After inserting the battery the green LED
flashes for approximately 20 seconds. During
power2max
this time your
broadcasting and you can pair it with your bike
computer (please refer to your bike computer's
manual for instructions).
Close the battery compartment and tighten the
screws with 0.15NM torque (with 2 fingers).
6. Install the rubber plugs and seals
(see also page 39)
Install the rubber plugs covering the screw
holes.
Install the seal.
Finished! You are now ready to start riding and
enjoying your new power2max
powermeter on your
power2max
powermeter is
powermeter!
25