Start-Up - power2max Type S Guide De L'utilisateur

7.3 Start-up

IMPORTANT: Ensure that no torque is applied
power2max
to the
start-up, e.g., by putting load on a pedal.
1. Insert the battery of Type CR2450. Please
ensure the correct polarity. The positive pôle
(the side with the writing on it) should face
inward, towards the crank.
IMPORTANT: the USB micro-plus is used
only for diagnostic and maintenance
operations at the factory.
2. Your power2max
external LED that indicates the status of
the powermeter. This LED allows you to
easily check the status of your
powermeter and is also used during initial
start-up.
After inserting the battery, the green LED
flashes for approximately 20 seconds. This
signals its readiness for use. During this period,
power2max
the
mitting its ANT+ signal and can be paired with
a compatible bike computer. Enter pairing mode
on your compatible bike computer. It should
recognize your power2max
pair automatically with it.
powermeter during
powermeter has
power2max
powermeter starts trans-
powermeter and
an
37