Festo DGO-12-A-B Notice D'utilisation page 26

DGO−...−A−B
2. Close the adjusting screws for the end
position cushioning on both sides
completely,
then loosen them one turn.
3. Pressurize the DGO−... as follows:
slow pressurization of one side or
simultaneous pressurization of both
sides with subsequent exhausting of
one side.
Otherwise excessive loadings will occur at the start when the slide moves into
an end position too quickly or without an air cushion.
For slow start−up pressurization, use start−up valve
type HEL−... / HEM−... .
4. Start a test run.
5. Check whether the following settings need to be modified.
the slide speed
the end position cushioning.
Mass geometries with projection in the longitudinal direction of the slide:
Warning
Note that the following screws must only
be turned when the DGO−... is at a stand:
the adjusting screws for the end
position cushioning
the adjusting screws for the one−way
flow control valves.
26
Ó Ó
Fig. 17
Ó
Ó Ó
Fig. 18
Ó Ó
Ó Ó
Fig. 19
Festo DGO−...−A−B 0410b English
Ó
Ó
Ó Ó
Ó Ó