Festo DGO-12-A-B Notice D'utilisation page 20

DGO−...−A−B
6 Fitting
Fitting mechanical components
Avoid damaging the cylinder barrel.
S
Damage to the cylinder barrel will reduce
the reliability and the service life of the
DGO−...
Place the DGO−... so that all the operating
S
parts are accessible (lubricating nipple,
adjusting screws).
Make sure that the drive is fitted free of
S
mechanical stress and distortion.
When the drive is fitted in a vertical position:
Make sure that the slide has reached a stable position when it comes to a
S
stand (e. g. the lowest point or secure it with a moveable bolt).
Work loads with their own guide:
Please note
Jamming and non−permitted bending, e. g. due to tilting torques, reduce the
service life of the DGO−... .
The max. permitted misalignment of parallel guiding is 1 mm.
S Make sure that a degree of freedom is maintained between the slide and the
work load.
Driver type FKG−... can be used for this purpose. (see chapter Accessories").
20
Fig. 5
Fig. 6
Ó
Ó
Ó
Fig. 7
Festo DGO−...−A−B 0410b English
Ó
Ó