Defrosting The Freezer Compartment; Replacing The Light Bulb - CONTINENTAL EDISON CERBC204EAP Guide D'utilisation

Réfrigérateur encastré
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Defrosting the Freezer Compartment:

WARNING: Never use sharp metal tools, unless recommended by manufacturer, for this
operation as they can damage the refrigeration circuit.
After a period of time, frost will build up in certain areas in the freezer compartment. The
frost, accumulated in the freezer compartment, should be removed periodically (use the
plastic scraper if available).
Complete defrosting will become necessary if the frost layer exceeds 3-5 mm to maintain
the efficiency of the freezer.
• The day before you defrost, set the thermostat dial to position "5" to freeze the foods
completely.
• During defrosting, frozen foods should be wrapped in several layers of paper and
kept in a cool place. The inevitable rise in temperature will shorten their storage life.
Remember to use these foods within a relatively short period of time.
• Set the thermostat knob to position "0" and switch off the appliance.
• Leave the door open to accelerate defrosting. Remove the defrost water from the
compartment.
• Clean the interior by hand with lukewarm water and a little detergent.
Never use abrasive products or aggressive cleaning agents.
• Dry the inside of the unit, plug on the mains, and set the thermostat knob to position
"5". After 24 hours, reset the thermostat to the desired position.

Replacing the Light Bulb

When replacing the bulb of the refrigerator compartment;
1. Unplug the unit from the power supply,
2. Press the hooks on the sides of the light cover top and remove the light cover
3. Change the present light bulb with a new one of not more than 15 W.
4. Replace the light cover and after waiting 5 minutes plug the unit.
(if available)
EN - 9 -

Publicité

Table des Matières
loading

Table des Matières