Horizon Fitness CT9.1 Manuel Du Propriétaire page 5

ASSEMBLY STEP 3
HArDWArE BAG 3 CONTENTS :
BOLT (A) SPRING WASHER (B)
20 mm 8.2 mm
Qty: 4 Qty: 4
ARC WASHERS (C)
SPRING WASHERS (B)
BOLTS (A)
CONSOLE MAST
8
CT9.1-CT12.1-OM-rev1.5.indd 8-9
A Open HArDWArE BAG 3.
Slide ConSoLE through the ConSoLE
B
ARC WASHER (C)
MAST BooTS.
8.2 mm
Qty: 4
NOTE: Make sure the arrows on the mast rings
are pointing upward towards the console when
sliding into place.
C Connect ConSoLE CABLES.
NOTE: Be careful not to pinch any wires
CONSOLE
while assembling the right console mast.
CONSOLE MAST BOOT
D Connect ConSoLE to riGHT ConSoLE
MAST using 2 BoLTS (A), 2 SPrinG
WASHErS (B) and 2 ArC WASHErS (C).
CONSOLE CABLES
Repeat on other side.
E
ASSEMBLY STEP 4
HArDWArE BAG 4 CONTENTS :
SCREW (D)
20 mm
Qty: 4
SCREWS (D)
MAIN FRAME BOOT
A Open HArDWArE BAG 4.
Attach MAin frAME BooTS using 4
B
SCrEWS (D).
C Before the first use, lubricate the treadmill
deck by following the instructions in the
MAINTENANCE section in the TREADMILL
gUIDE.
YOU ARE FINISHED!
12/23/09 11:06 AM
9