Before The First Use - Domo DO704K Mode D'emploi

PARTS
1. Filter holder
2. Swivel filter
3. Drip stop
4. Glass carafe of 1,5 l
5. Keep-warm plate
6. Water tank with water level
indications
7. Carafe lid
8. On/off button with indicator
light
9. Handle

BEFORE THE FIRST USE

· Check if all accessories are included and if the appliance is not damaged.
· First let water run through the appliance, without adding coffee. To do so, fill the water
tank up to the maximum level, switch on the coffee maker and let the water run through
completely. Dispose of the water and repeat one or two times. Afterwards, clean the filter,
filter holder, carafe and lid of the carafe thoroughly with warm water.
USE
1. Open the lid of the water tank, and use the glass jug to add the required amount of
water. The amount of water should not exceed the maximum indication.
2. Pull the handle on the swivel lever so that it swings open to the left.
3. Place the filter holder back in the machine so that the handle is
turned towards you.
4. Put a paper filter into the filter holder.
5. Pour the desired amount of coffee into the filter. Close the swivel
filter.
6. Insert the glass carafe horizontally into the coffee maker. Put it on the keep-warm plate,
under the drip stop.
7. Plug the power cord into the outlet and press the on/off button. The indicator light
will light up and the coffee maker will start brewing. You can remove the carafe from
the coffee maker at any chosen time for a maximum of 30 seconds to pour coffee. The
appliance will stop dripping automatically.
8. The coffee is ready about one minute after the coffee stops dripping from the appliance.
· The final amount of coffee will always be a little less than the amount of water you put
in, because the coffee absorbs water.
24
DO704K
1
2
3
4
5
6
7
8
9