Before First Use - Domo DO473K Mode D'emploi

www.domo-elektro.be
First turn off the device, leave it to cool off and only
then replenish the reservoir.
PARTS
1. Permanent filter
2. Filter holder
3. Control panel
4. Measuring scoop
5. Glass jug
6. Lid
7. Water level indication
8. Keep warm plate

BEFORE FIRST USE

• Check whether all parts are present and
whether or not the device has been damaged in transport.
• Fill the water reservoir with pure water and let it run twice without adding any
coffee.
• Pour out the water and clean all removable accessories thoroughly in warm water.
USE
1. Open the lid and fill the water reservoir with water. The water level may not
exceed that of the max level indicated on the reservoir.
2. Place the permanent filter in the filter holder and ensure the permanent filter has
been installed properly. You may also use a paper filter.
3. Place the ground coffee in the filter. For each cup of coffee you may use one level
spoon of ground coffee but you may adjust to fit your own taste. Next, close the
lid.
4. Now place the glass jug on the keep warm plate.
5. Plug in the device. The display shows «12:00» and the colon will blink.
6. Press the ON/OFF button, the ON indication light will light up red. The device
starts working.
7. You may interrupt the coffee brewing at any time by pressing the ON/OFF button
once at any given point. The ON indication light will switch off and the green
AUTO indication light will switch on. Press the ON/OFF button one more time to
fully power down the device. The water that is already running through the coffee
filter will still run down into the glass jug. When you press the ON/OFF button
again, the device will start up again.
Remark: You can pour coffee at any given time. The device will automatically
stop dripping. You only have 30 seconds to pour.
1
2
3
4
5
31
DO473K
6
7
8