Ice Maker/Ice And Water Dispenser - Gaggenau RF 411 Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Ice Maker/Ice and Water Dispenser

Fault
No water can be drawn but ice is
discharged.
The Ice Maker doesn't work.
No water or ice is available at the
Dispenser.
The Ice Maker does not make
enough ice or the ice is
deformed.
The Ice Maker does not make any
ice.
Possible cause
Devices defect.
Ice Maker is not connected to the power
supply.
Ice Maker does not contain any fresh
water.
Temperature in the Freezer
Compartment is too warm.
The Ice and Water Dispenser Control
Panel is locked (childproof lock).
Water Tank fills up.
Appliance and Ice Maker were switched
On only recently.
A lot of ice has been taken.
Low water pressure.
The Filter Cartridge is blocked or needs
to be replaced.
The appliance or Ice Maker has only just
been switched On.
A lot of ice has been taken.
Low water pressure.
The Filter Cartridge is blocked or needs
to be replaced.
Temperature in the Freezer
Compartment is too warm.
The Ice Maker is switched Off.
The appliance is not supplied with water. Contact the installer or the Water Supply
Water Supply has kinks.
Low Water Pressure.
Temperature in the freezer space is too
warm.
Ice Cube Container is not properly
inserted.
Incorrect Shut Off Tap installed.
Remedial action
Call Customer Service.
Call Customer Service.
Ensure that the water is properly connected.
Set temperature slightly colder in the Freezer
Compartment.
Unlock the Ice and Water Dispenser Control
Panel.
When used for the first time, it takes about
2 minutes for the Water Tank fill up.
Approximately 24 hours are needed until ice
production starts.
Approximately 24 hours are needed until the
Ice Cube Container is filled.
Connect the appliance to the stipulated water
pressure only (see chapter "Connecting
Appliance", section "Water Connection").
Exchange the Filter Cartridge.
Approximately 24 hours are needed until ice
production starts.
Approximately 24 hours are needed until
the Ice Cube Container is filled again.
Connect the appliance to the stipulated water
pressure only (see chapter "Connecting
Appliance", section "Water Connection").
Exchange the Filter Cartridge.
Set temperature slightly colder in the Freezer
Compartment.
Switch the Ice Maker On at the control panel.
company.
Turn Off the Water Supply at the Shut Off Tap.
Smoothen out the kinks, exchange where
necessary.
Connect the appliance to the stipulated water
pressure only (see chapter "Connecting
Appliance", section "Water Connection").
Check Freezer Compartment temperature and,
if required, set slightly colder.
Check the position, re-insert where necessary.
Incorrect Shut Off Taps can cause low water
pressure and damage to the appliance.
23

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Rf 413Rf 461Rf 463Rf 471

Table des Matières