Seca 952 Mode D'emploi Et Garantie page 15

The display is reset to zero.
in the display. The note "NET" appears.
– Now put the patient and the additional
weight on the scale.
The scales calculate the patient's
weight without
weight.You can now perform as many
weighing operations as you like.
– Hold the key down again to deactivate
the Tare function; the scale is then back
in normal weighing mode and the tare
value has been erased.
– The tare value is likewise erased by the
scale being switched off.
5. Cleaning
Clean the seat and the housing as required using a domestic cleaning agent or commer-
cially-available disinfectant. Follow the manufacturer's instructions.
Under no circumstances use abrasive or acid cleaners, white spirit, benzene or the like for
cleaning. Such substances can damage the high-quality surfaces.
6. What do I do if...
... no weight display comes on?
– Is the scale switched on?
– Check the batteries.
... 0. 0 does not appear before weighing?
– Switch off the scale with the Start key and start the scale again – there must not be
any load on the scale – and only its feet should be in contact with the floor.
... one segment is illuminated constantly or not at all?
– The relevant segment has a fault. Inform Servicing.
... the display shows
– Battery voltage is running low. Change the batteries in the next few days.
batt
... appears in the display?
– Batteries are empty. Put in new batteries.
St0p
... appears in the display?
– Maximum load has been exceeded.
... the display flashes?
– If you have just activated the Hold or Tare function, please wait until the scale has de-
tected a steady weight value. The display will then stop flashing.
Model 952
0. 0
appears
the additional
?
0. 0
kg
NET
15