Getting To Know Your Appliance; The Control Panel; The Hotplates; Residual Heat Indicator - NEFF T1 D2 Série Mode D'emploi

Getting to know your appliance

The instruction manual is the same for various different hobs.
An overview of the models with their dimensions is given on
page 2.

The control panel

) FKLOGSURRI ORFN
Controls
When you touch a symbol, the respective function is activated.

The hotplates

Hotplate
Single-circuit hotplate
$
Dual-circuit hotplate
ð
When the hotplate is activated: the corresponding display lights up.

Residual heat indicator

The hob has a two-stage residual heat indicator for each
hotplate.
If appears in the display the hob is still hot. It may be used,
•
for example, to keep a small meal warm or to melt cooking

Setting the hob

This section informs you how to set the hotplates. The table
shows heat settings and cooking times for various meals.

Switching the hob on and off

The main switch is used to switch the hob on and off.
To switch on: touch the
#
main switch lights up. The hob is ready for use.
To switch off: touch the #
main switch goes out. All hotplates are switched off. The
residual heat indicator remains on until the hotplates have
cooled down sufficiently.
Note: The hob switches off automatically if all hotplates have
been switched off for more than 20 seconds.
20
&RQWUROV IRU
&RQWURO IRU
PDLQ VZLWFK
&RQWURO IRU
KHDW VHWWLQJ DGMXVWPHQW
Activating and deactivating
Touch the
symbol. The indicator above the
symbol until the display above the
'LVSOD\V IRU
³É KHDW VHWWLQJ
‡¤ UHVLGXDO KHDW
¯ RSHUDWLQJ UHDGLQHVV
&RQWUROV IRU
 WLPHU DFWLYDWLRQ
 DQG  WLPHU
DGMXVWPHQW
Notes
The settings will remain unchanged if you touch several
■
symbols at once. This allows you to wipe up spills on the
control panel.
Always keep the controls dry. Moisture reduces their
■
effectiveness.
symbol
ð
chocolate. As the hotplate cools down further, the display
changes to . The display remains lit until the hotplate has
œ
cooled sufficiently.

Setting a hotplate

Use the + and - symbols to set the desired heat setting.
Heat setting 1 = lowest setting
Heat setting 9 = highest setting
There is an intermediate setting between each heat setting. This
is identified by a dot.
&RQWUROV IRU
Í GXDOFLUFXLW
KRWSODWH
ZLSH SURWHFWLRQ