Getting To Know Your Appliance; The Control Panel; The Hotplates; Residual Heat Indicator - NEFF T1.D10 Serie Mode D'emploi

Getting to know your appliance

An overview of the models with their dimensions is given on
page 2.

The control panel

Controls
When you touch a symbol, the respective function is activated.

The hotplates

Hotplate
Single-circuit hotplate
$
Dual-circuit hotplate
ð
When the hotplate is activated: the corresponding indicator lights up.

Residual heat indicator

The hob has a two-stage residual heat indicator for each
hotplate.
If appears in the display the hob is still hot. It may be used,
•
for example, to keep a small meal warm or to melt cooking

Setting the hob

This section informs you how to set the hotplates. The table
shows heat settings and cooking times for various meals.

Switching the hob on and off

The main switch is used to switch the hob on and off.
To switch on: touch the #
main switch lights up. The hob is ready for use.
To switch off: touch the
#
main switch goes out. All hotplates are switched off. The
residual heat indicator remains on until the hotplates have
cooled down sufficiently.
22
&RQWURO IRU
VHOHFWLQJ WKH KRWSODWH
&RQWUROV IRU
PDLQ VZLWFK
FRQWURO SDQHO SDXVH
/ NHHS ZDUP IXQFWLRQ
/ FKLOGSURRI ORFN
Activating and deactivating
Use the ( ) symbol to select the hotplate. Touch the
symbol. The indicator above the
symbol until the display above the
'LVSOD\V IRU
KHDW VHWWLQJ³É
UHVLGXDO KHDW ‡¤
RSHUDWLQJ UHDGLQHVV ¯
&RQWUROV IRU
DGMXVWPHQW
&RQWURO IRU
Í DFWLYDWLRQ
âWLPHU IXQFWLRQ
Notes
The settings will remain unchanged if you touch several
■
symbols at once. This allows you to wipe up spills on the
control panel.
Always keep the controls dry. Moisture reduces their
■
effectiveness.
chocolate. As the hotplate cools down further, the display
changes to
œ
cooled sufficiently.
Notes
The hob switches off automatically if all hotplates have been
■
switched off for more than 15 seconds.
The settings remain stored for 4 seconds after the hob has
■
been switched off. If you switch it on again during this time,
the hob will operate using the previously stored settings.

Setting a hotplate

Use the + and - symbols to set the desired heat setting.
Heat setting 1 = lowest setting
Heat setting 9 = highest setting
There is an intermediate setting between each heat setting. This
is identified by a dot.
&RQWURO IRU
activation symbol
ð
. The display remains lit until the hotplate has