Operating Instructions - Wilo CRONOLINE-IL-E Série Notice De Montage Et De Mise En Service

8.6

Operating instructions

8.6.1 Adjusting the setpoint
12.3
Fig. 33: Entering the setpoint
8.6.2 Changing to menu mode
2 s
ON
1
12.3
Fig. 34: Standard menu mode
2 s
ON
1
12.3
Fig. 35: Service menu mode
E000
Fig. 36: Error case menu mode
Installation and operating instructions Wilo-CronoLine-IL-E, CronoTwin-DL-E, CronoBloc-BL-E
1.0.0.0
• Turn the red button.
2200
RPM
• To confirm the change, press the red button.
1.0.0.0
1800
RPM
2 s
• While the display is showing the status page, press the red button for
±
2.0.0.0
±
5.0.0.0
±
6.0.0.0
On the status page of the display, the setpoint can be adjusted as
follows (Fig. 33):
The display changes to menu number <1.0.0.0>. The setpoint begins
to flash and is increased or decreased by continuing to turn.
The new setpoint will be accepted and the display will return to the
status page.
To change to menu mode, proceed as follows:
two seconds (except in case of an error).
Standard behaviour:
The display changes to menu mode. Menu number <2.0.0.0> is
displayed (Fig. 34).
Service mode:
If service mode is activated via DIP switch 1 menu number <5.0.0.0>
is displayed first (Fig. 35).
Error case:
In case of error, menu number <6.0.0.0> is displayed (Fig. 36).
English
95