Table des Matières
Publicité
§2.5 - Protection against unauthorized use
On/off isolator switch for the HTL in the vehicle cabin
Battery switch on the power pack of the HTL
§2.6 - Electrical control devices
Wander lead with spiral cable
Emergency cut-off switch / dead-man switch
Protection rubbers on the buttons & switches
15A fuse in the power pack
Electrical contacts (in the various control units)
§2.7 - Electrical installation
Batteries
25mm² (+) BATTERY cable to the battery
25mm² (-) EARTH cable to the battery or earth point
Electrical plug connections
100/250A main fuse near the battery
Battery switch on the power pack
Cable boom & loop inside the cassette
25mm² (+) BATTERY & (-) EARTH cables
Cables between exterior control box and power pack
Cables to the lift arms (platform lights and switches)
All cable connections inside the exterior control unit
All cable connections inside the power pack
Limit switches, position switches, pressure switches, reed sensors, interlocks
with the vehicle...
DHOLLANDIA
EN
What to verify? Execute, service or repair if required !!
•
General condition
•
Function & operation
•
General condition
•
Function & operation, automatic return to the neutral 0-position (all switches)
What to verify? Execute, service or repair if required !!
•
General condition
•
Function & operation
•
Automatic return to the neutral 0-position (all switches)
Conditions of electrical cables, wires, and protection rubbers
•
•
General condition
•
Moisture inside the control unit & corrosion
•
Fixation & tightening of all cable & wire connections
What to verify? Execute, service or repair if required !!
General condition
•
•
Good mounting & fixation of electrical cable & wire connections (see fitting instructions)
•
Technical maintenance of the batteries, power circuit, battery charging circuit and earth circuit
•
Apply grease or Vaseline to all connections to protect them against corrosion
•
General condition
•
Corrosion, burn marks / arcing
Good tight fixation of the 25mm² (+) BATTERY & (-) EARTH cables
•
•
Apply grease or Vaseline to all connections to protect them against corrosion
•
Routing & guidance, protection against squeezing, sheering or rubbing
•
Damage, good insulation & protection
•
Sufficient fixation to the vehicle body or chassis
•
Clearance from dangerous vehicle components (exhaust, braking circuit, drive & engine parts,
...)
General condition, insulation of the separate wires
•
•
Moisture inside the control unit & corrosion
•
Fixation & tightening of all cable & wire connections
•
General condition
Function & operation, automatic return to the neutral 0-position
•
B23
Freq.
W52
M3 J1
W52
M3 J1
Freq.
W52
M3 J1
J1
Freq.
M3 J1
M3 J1
M3 J1
M3 J1
W52
M3 J1
Publicité
Table des Matières
