Num'axes CANICOM 200 Guide D'utilisation page 26

The symbols which appear indicate the following:
Battery fully charged.
Weak battery: prepare to replace the battery.
Dead battery: your CANICOM 200 functions in safety mode and the system locks up. The
battery must be replaced.
NUM'AXES advises to use the same type and same brand of batteries as those supplied in your new
purchased product. Other brands of batteries may not operate, or may not be completely compatible
with your product.
You can purchase the suitable batteries from NUM'AXES or from your distributor.
Replace the old battery with a new one as follows:
- On the back of the remote control, unscrew the screw and remove the battery cover.
- Remove the old battery.
- Insert the new battery (3-V lithium CR 2430) making sure the polarity "+" noted on the battery is
visible (ref. Diagram 6).
- Put the battery cover back in place.
- Retighten the screw.
- Check the remote control operates correctly.
« + » of the battery
must be visible
Gb - 26
Diagram 6