Sinmag Europe PLANETO 20L Mode D'emploi page 15

Before starting to operate the machine, the bowl has to be inserted correctly into the arms
of the machine and it should be fixed with the vanes. The tool itself (the whip, flat beater or
hook) also has to be fixed correctly into the machine's head.
The bowl then has to be raised by means of the handle, this handle will experience some
resistance before it can be fixed in its position. For the Spiralo 80L with a switch.
You will have to lower the safety grid and lift bowl before you will be able to start the
machine. You should also see to it that the emergency stop is not pushed in. The machine
will not start if the digital panel shows '
bowl is not raised or the emergency stop is pushed in.
If the digital panel does not shows this error message, the machine is ready to start. Now,
you just have to push the green button to start the machine.
The machine is equiped with ten gears. In order to switch gears, you just have to push the
arrows on the left-hand side of the digital control panel.
One push on the switches the machine to a higher gear, one push on the
machine to a lower gear.
To operate the timer, you have to use the right-hand side of the digital control panel. Again,
one push on the increases the set time by one minute, one push on the
set time by one minute. When the timer reaches '
off. Of course, you can also operate the machine without having to use the timer. In that
case, the timer indicates '
To stop the machine manually, you just have to push the stop button.
The machine must not be overloaded, if you want to mix heavier dough or
other products, the machine should be operated in a low gear. Otherwise the
transmission may get damaged.
' ' '. this means that the safety grid is raised, the
Op en
'.
--
', the machine is automatically switched
00
ENG
switches the
decreases the
15