Aventics HF03 LG Mode D'emploi page 70

70 AVENTICS | EtherCAT | R412012792–BDL–001–AB
Commissioning and operation
1)
Examples Subbases used
Example 1 Subbases for double solenoid valves
Example 2 Subbases for double solenoid valves
Example 3 Subbases for double solenoid valves
Example 4 Subbases for single solenoid valves
Example 5 Subbases for double solenoid valves
combined with
Subbases for single solenoid valves
Example 6 Subbases for double solenoid valves
combined with
Subbases for single solenoid valves
1)
You can also arrange other combinations based on your requirements.
Examples for assignment of switch S4 and the supply of
assembled valves for 32 valve solenoids can be found in
Tab. 10 and Tab. 11 on pages 71 and 72 (examples 1 to 3/
examples 4 to 6, respectively). The following example
combinations are listed there:
From an electrical connection viewpoint, the
subbases for double solenoid valves must come first
and then those for single solenoid valves. The
maximum number of solenoids for all subbases
is 32.
The assignment of switches and valve supplies
changes if module expansions are used (see
operating instructions R412008961). This also
applies to the following examples in Tab. 10 and
Tab. 11.
Valve equipment
Double solenoid valves
Single solenoid valves
Single and double solenoid
valves
Single solenoid valves
Double solenoid valves
Single solenoid valves
Single and double solenoid
valves
Single solenoid valves