Spray Arms - Gaggenau DF 280 Notice D'utilisation

en-us
Care and Maintenance
When washing normally attached food soils that have
been scraped before loading, in a household that runs
the dishwasher every other day, your filter should be
cleaned:
Cleaning interval Use this setting,
3 times a year if you rinse before loading
4 times a year if you only scrape before loading
6 times a year if you do not rinse or scrape
before loading
12 times a year if you have hard water
Note: Clean the filter after washing loads with large
amounts of food soils or loads with a heavy starch
content to maintain optimal performance.
To check or clean the filter system:
1.
After each wash cycle check the filters for residue.
2.
Unscrew the Large Object Trap as illustrated and
remove the entire filter system.
36
3.
Remove any residue and clean filters by rinsing
under running water.
Note:do not use abrasive brushes or steel wool, etc.,
as they may damage the filter.
4.
Reinstall the filter system in reverse sequence and
lock into place by screwing the Large Object Trap
until the marking arrows align.

Spray arms

Limescale and contaminants in the rinsing water may
block nozzles and bearings on the spray arms 1:
and 1J.
1.
Check outlet nozzles on the spray arms
for blockages.
2. Unscrew the upper spray arm 1: (1) and remove
downwards (2).
Remove the lower spray arm 1J upwards.
3.
4.
Clean spray arms under running water.
5.
Re-engage or screw on spray arms.