Maintenance And Cleaning; Repair; Taking Out Of Service - Franke FHMF 604 3G DC C Manuel D'utilisation

EN
In the case of a fire, switch off the
Z X
appliance and cover flame e.g. with a lid or
with a fire blanket.
To avoid damaging the appliance
In the case of thermal failure, switch the
Z X
solid plate off and allow to cool down
completely.
Do not put any dishes on it. Do not cool
Z X
with cold water under any circumstances.
Do not climb onto the appliance.
Z X
Do not leave the appliance unattended
Z X
during operation.
If the appliance has a lid, make sure the
Z X
burners are cold before closing it
The hob is an item for daily use: signs of
usage such as scratches or visible material
abrasion from pots or cookware are normal.
Intensive use leads to more distinctive
signs of usage. In such cases, the appliance
continues to function perfectly and a
complaint is not justified. Safety is always
guaranteed.

Maintenance and cleaning

Before any cleaning or maintenance
Z X
operations disconnect the appliance from
the mains power supply.
Do not use steam cleaners or direct jets of
Z X
water.
Never use scouring pads, steel wool,
Z X
muriatic acid or other products which
could scratch or mark the surface.
Do not use products containing sands,
Z X
alkalis, acids, chlorides, oven sprays
or detergents normally used to clean
dishwashers.
Never use sharp objects, as they could
Z X
damage the seals between the trim and
worktop.
Do not leave acid or alkaline substances
Z X
on the hob.
Always thoroughly dry the appliance after
Z X
going over it with a damp cloth to prevent
scale deposits from forming.
Remove grime with a damp cloth.
Z X
Do not clean the grates, burner caps and
Z X
flame-spreaders in the dishwasher. Clean
FHMF 604 3G DC C / FHMF 604 4G C / FHMF 755 4 G DC C
.
– 6 –
them with hot soapy water, making sure to
carefully dry them.
Ensure the gas outlet zones are perfectly
Z X
clean.
Risk of electric shock due to entering
liquid!
The device contains electrical components.
Make sure that no liquid enters the interior
Z X
of the device.
Do not use pressurised steam to clean the
Z X
device.

Repair

The appliance is manufactured in compliance
with the relevant effective safety standards.
Do not allow anyone except qualified
Z X
personnel to install or repair the appliance.
Contact a service centre authorised by the
Z X
manufacturer or qualified personnel in the
following cases:
– Immediately after unpacking, in the event of
doubts regarding the integrity of the device
– During installation (according to the
manufacturer's instructions)
– Doubts regarding the correct operation of
the device
– Malfunction or poor operation
– Replacing the power socket if incompatible
with the power plug of the device
– If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.
Use original spare parts only.
Z X

Taking out of service

If the appliance is no longer to be used, call
Z X
the service centre or qualified personnel to
disconnect it from the power supply.