Cleaning And Maintenance; Troubleshooting; Sounds Produced During Operation - Franke FMA 654 I F BK Manuel D'installation Et Mode D'emploi

CLEANING AND MAINTENANCE

WARNING
!
• Do not use steam cleaning equipment.
• Before cleaning, make sure the cooking zones are switched off and that the residual heat indicator ("H") is not displayed.
Important:
• Do not use abrasive sponges or scouring pads as they may damage
the glass.
• After each use, clean the hob (when it is cool) to remove any deposits
and stains from food residue.
• A surface that is not kept suitably clean may reduce the sensitivity of
control panel buttons.
• Use a scraper only if residues are stuck to the hob. Follow the scraper
manufacturer's instructions to avoid scratching the glass.

TROUBLESHOOTING

• Check that the electricity supply has not been shut off.
• If you are unable to turn the hob off after using it, disconnect it from the
power supply.
• If alphanumeric codes appear on the display when the hob is switched on,
consult the following table for instructions.
DISPLAY CODE
Cookware is detected but it is not
compatible with requested operation.
F0E1
Wrong power cord connection.
F0E7
The control panel switches off because
F0EA
of excessively high temperatures.
F0E2, F0E4, F0E6, Disconnect the hob from the power supply.
F0E8, F0EC, F1E1, Wait a few seconds then reconnect the hob to the power supply.
F6E1, F7E5, F7E6 If the problem persists, call the service centre and specify the error code that appears on the display.
d E The hob does not switch heat up.
The functions do not come on.
[when the hob is off]
The hob does not allow a special
function to be activated.
e.g. :
The hob automatically sets a minimum
e.g.
power level to ensure that the cooking
[Power level lower than
zone can be used.
level requested]

SOUNDS PRODUCED DURING OPERATION

Induction hobs may whistle or creak during normal operation.
These noises actually come from the cookware and are linked to the
characteristics of the pan bottoms (for example, when the bottoms are
made from different layers of material or are irregular).
DESCRIPTION
The cookware is not well positioned on
the cooking zone, or it is not compatible
with one or more cooking zones.
The power supply connection is not
exactly as indicated in "ELECTRICAL
CONNECTION" paragraph.
The internal temperature of electronic
parts is too high.
DEMO MODE on.
The power regulator limits the power
levels in accordance with the maximum
value set for the hob.
The power regulator limits the power
levels in accordance with the maximum
value set for the hob.
• Sugar or foods with a high sugar content can damage the hob and
must be immediately removed.
• Salt, sugar and sand could scratch the glass surface.
• Use a soft cloth, absorbent kitchen paper or a special hob cleaner
(follow the Manufacturer's instructions).
• Spills of liquid in the cooking zones can cause the pots to move or vibrate.
• After cleaning the hob, dry thoroughly.
Please note: The presence of water, liquid spilled from pots or any objects
resting on any of the hob buttons can accidentally activate or deactivate
the control panel lock function.
POSSIBLE CAUSES
These noises may vary according to the type of cookware used and to the
amount of food it contains and are not the symptom of something wrong.
– 12 –
SOLUTION
Press On/Off button twice to remove the
F0E1 code and restore the functionality
of the cooking zone. Then, try to use the
cookware with a different cooking zone, or
use different cookware.
Adjust the power supply connection
according to "ELECTRICAL CONNECTION"
paragraph.
Wait for the hob to cool down before using
it again.
Follow the instructions in the "DEMO
MODE" paragraph.
See paragraph "Power management".
See paragraph "Power management".