Télécharger Imprimer la page

EUROM Safe-t-Shine 1200 Manuel D'utilisation page 18

Masquer les pouces Voir aussi pour Safe-t-Shine 1200:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
This heater has been designed to be used as a stand-alone unit; never use the
heater when it is hanging, leaning, etc.!
Caution! A push button is located beneath the heater: this is the safety tip-over
cut-out switch. Knocking over the heater will cause this button to protrude and
the heater will turn off automatically. This means the heater will not work when
hanging.
Make sure a functioning heater is always placed on a solid, flat and horizontal
surface.
Check that all buttons are in the off position, in other words not pressed.
Fully extend the power cord and plug into a suitable 220-240V socket (≥
10Amp.). Only connect the heater to an earthed socket!
Use and operation
Press the red On/Off button (7). The middle quartz light will start to operate
(400W).
If desired, use the control buttons (8) to also switch on the top and bottom lights
(both 400W).
To switch the top or bottom light off again, press the corresponding control button
again.
If you now press the oscillation button (9) the device will swivel horizontally
approximately 60°. Press the button again in order to de-activate the function.
Press the On/Off button again in order to switch the device off completely. Then
remove the plug from the socket. Never leave the heater plugged in when it is not
in use!
Please note: When you use the heater for the first time, a little smoke and an
odour may be produced. This is normal and harmless, and should cease after a
few minutes. If the heater does not stop smoking, switch the heater off, remove
the plug from the socket and contact your supplier.
The heater, and particularly the radiation grid, become extremely hot during use
and will also remain warm for some time after the heater has been switched off.
Take this into account!
If you wish to relocate the heater, first switch it off, remove the plug from the
socket and allow it to cool down before moving it. To relocate the heater, use the
handle.
In order to prevent over-heating, never cover the heater!
WARNING! Some parts of this product could become very hot and cause
burns. Be especially careful if children or vulnerable persons are in the
Safety features
The heater is fitted with a tipping safeguard which automatically shuts off the
appliance if it inadvertently falls over. However, this does not rule out all risks: even
after the heater has been switched off, it and particularly the radiation grid, will
remain very hot for some time and if it is left lying, for example, on a wooden floor or
carpet, it can cause fire/melting/scorching damage and result in a fire. Therefore
remain cautious at all times!
immediate vicinity.
18

Publicité

loading

Ce manuel est également adapté pour:

35.161.3