EUROM Safe-t-Shine 1200 Manuel D'utilisation page 17

25. Do not use attachments and/or accessories that have not been recommended
or supplied by the manufacturer.
26. Do not turn on the appliance if you have discovered damage to the appliance,
cord or plug, if the appliance is malfunctioning, if it has been dropped or when
there are signs of any other defect. Return the complete product to the vendor
or to a certified electrician for inspection and/or repair. Always ask for original
parts.
27. The appliance (incl. cord and plug) may only be opened and/or repaired by
properly authorised and qualified persons.
28. Only use this heater for its intended purpose and as described in this instruction
manual.
Not abiding by instructions 25, 26, 27 & 28 may lead to damage, fire and/or personal
injuries. A failure to adhere to these rules also immediately nullifies the guarantee
and vendor, importer and/or manufacturer do not take responsibility for
consequences!
Description
1. Handle (back)
2. Casing
3. Radiation grill
4. Reflector
5. Quartz lamp (3x400W)
6. Base
7. On/off button
8. Control button (2x)
9. Oscillation button
Assembly,
Location and Connection
Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact your
vendor for inspection or replacement.
The device consists of two parts that you must fit together before use: the actual
device and the base (6).

Lead the electrical cable with plug through the middle hole in the base; from top
to bottom (the hollow side of the base is the underside).

Now slide the base over the small white box with the electrical
cable on the underside of the device: all hollow spaces and
protrusions and screw holes on top of each other. It only fits in
one way.

Now firmly fasten the base and the device together using the
two safety screws included in the package.

Lead the electrical cable through the cable clamps and recess
to outside the base and place the device upright (see picture:
Description).

Choose a suitable location for the heater which is at least one metre away from
any obstructions, walls or inflammable materials (see also safety instructions).
17
any of the