EUROM GOLDEN 2000 AMBER FOCUS Mode D'emploi page 21

The reset button
You can use the reset button in three situations (see below):
- To operate the device without the remote control. Every time that you press the reset
button (briefly), the output changes from: > 2000 W > 1320 W > 660 W > off.
- To switch the device back on without the remote control, after the shock safeguard
has turned it off (see: Shock safeguard).
- To set or change the password for the app control.
- If you press the reset button for least 4 seconds, the device will return to the factory
settings.
App control
The EUROM GOLDEN 2000 AMBER FOCUS can also be
controlled by an app that has been downloaded to a
tablet or smartphone (via a blue tooth connection).
This app is available in the app store for Apple devices
and can be found under EUROM heating. It is
available for Android in the Google Play Store.
If you have switched the device on with the app and
then continue to control it with the remote control or
manual controls, the bluetooth connection will be
broken. If you then wish to reuse the app controls,
you must first restore the blue tooth connection.
With the app, you can:
- Remotely switch the device on and off
- Gradually adjust the heat from 0 to 100%
- Set a timer that automatically switches the device off
- Set the sensitivity of the shock safeguard
- Set multiple heaters individually
The app controls are secured with a password.
Shock safeguard
The EUROM GOLDEN 2000 AMBER FOCUS has the option of a shock safeguard that
switches the device off if it is shocked in any way. The shock safeguard can be activated
with the app and the sensitivity can then be set on a sliding scale. When the device is
supplied from the factory, the shock safeguard is off. Once the shock safeguard has been
activated, it can be operated via the remote control or manually. If the shock safeguard
has switched the device off, the red light at the reception point will blink. Check to
ensure that the device has not been damaged. If everything is ok, you can restart the
device by:
- Using the remote control to switch the device off and then on again
- Switching it off and on again using the switch, and then selecting the desired output
using the reset button (remote control)
- Switching the device off and on again with the app
21