EUROM GOLDEN 2000 AMBER FOCUS Mode D'emploi page 18

The EUROM GOLDEN 2000 AMBER FOCUS has a separated electrical part with the
receiving point for the remote control and a display. The reset button (6) and the On/Off
switch (5) are located at the rear.
The EUROM GOLDEN 2000 AMBER FOCUS is equipped with a top quality 2000W Golden
Amber ULG lamp that produces 90% less light.
Alongside the comfortable 2000W heat, the Golden ULG lamp also emits a natural, warm,
subtle glow. The lamp has an expected life of 8,000 hours; under normal circumstances, it
should not have to be replaced.
Very intensive use can lead to precocious aging of the lamp and of course an accident can
break it. In that case, contact your dealer or a qualified electrician. The lamp has a special
connection and it is not allowed to not-qualified people to remove or change it.
INSTALLATION
The EUROM GOLDEN 2000 AMBER FOCUS can be installed in 2 ways:
 Suspension from a wall (or possibly ceiling) by means of a wall bracket
 Suspension from a frame (parasol, tent or similar item) by means of a bracket
Remove all package material (including the shock absorbing material around the bulb)
before installating the heater and check the appliance, supply cord and the plug for signs
of damage.
Carefully choose the right place to install your heater.
Before fastening, check that the minimum safe distances between the surroundings and
the chosen location are respected:
Minimum distance lowest point of heater – floor: 1,8 metres
Minimum distance heater – heated object: 1 metre
Minimum distance top* heater – fire-resistant ceiling: 0.25 metres
Minimum distance top* heater – tent tarpaulin, parasol etc.: 0.5 metres
Minimum distance side heater – walls, obstacles, objects: 0.5 metres
* The top of the heater is the side where the suspension bracket is attached.
If you suspend the device outside, ensure that it is protected from the wind.
Before installing, secure the hanging bracket (9) to the heater. Using the Allen key, undo
the Allen screw (10) and pull the pin with the other screw out of the hole. Place the
hanging bracket (9) between both holes as indicated on the diagram. Push the pin with
the second screw back through the holes and the hanging bracket. Then place the first
Allen screw back and turn to secure using the Allen key.
1 – Suspension from a wall (or possibly ceiling) by means of the wall bracket
 The appliance has to be mounted preferably on an incombustible foundation. That
foundation has to be vibrationfree, exact vertical and stable enough for lastingly
holding the appliance free of problems. Check whether the cotter bolts that are
included fit, are sufficiently strong and are suitable for the substrate. The material
18