Setting Up The Sewing Machine - JUKI MS-1190 Manuel D'utilisation

Model

1. SETTING UP THE SEWING MACHINE

!3
!5
!2
1
4
6
7
8
9
!4
2
3
5
4
6
!1
JUKI New Defrix Oil No.1
1) When carrying the sewing machine, be sure to carry
by two people.
(Caution) Do not hold the pulley.
2) Do not place a protruding object, such as a screw
driver, at a place where the sewing machine is to be
installed.
3) Attach belt dodging base 1 to the sewing machine
!0
with hexagon head bolt 2 .
4) Put the sewing machine on the table and determine its
position (belt groove and through hole 3 for passing
the presser bar lifter chain).
5) Attach two machine head support plates 4 to the
sewing machine by means of screw 5 . Fix the plates
on the table by means of hexagonal bolt 6 , washer 7 ,
spring washer 8 and nut 9 .
6) Place a level on bed side plate !0 in a lateral direction
and a longitudinal direction to check that the sewing
machine is properly placed in a horizontal position.
7) Install belt cover !1 , V belt, belt cover lid !2 , and top
cover !3 on the sewing machine and fix them with
screws !4 and !5 .
When installing the belt over, temporarily tighten the
screw fi rst. Then, securely tighten the screw after the
installation of all related parts.
– 1 –