Texas 335 – 532 Manuel De L'utilisateur page 6

Find information about the motor in the Motor manual instruction.
Adjustment of depth skid
Adjustment of support wheels
Cleaning of cultivator
Maintenance of cultivator
Chassis gearbox
The depth skid is mounted on the cultivator. To
adjust depth skid, pull it backwards and up till the
preferred height is found. Place the depth skid
vertically, and it will fall into a notch.
The depth skid can be adjusted in several
cultivating depths. If you press the depth skid too
deep into the soil, the rate of advance will slow
down and the cultivating depth will increase.
The right cultivating depth will lighten your
workload. If you raise the depth skid the rate of
advance will increase, but the cultivating will be
more super-ficial.
The right adjustment depends on the soil.
The supportwheels are mounted on the cultivator.
The adjustment is done by means of the lock . Pull
the lock out, and lift or lower the cultivator with
the handlebar until the preferred height is found.
Release the lock.
The support wheels avoid the machine to go into
the ground and they are stablising the machine
during operating while cultivating.
The cultivator should be cleaned after use. Use
your garden hose and wash down soil and dirt.
Clean the rotor-shaft for grass, string etc. The
chassis number should only be cleaned with a
moist cloth otherwise it might fall of. Avoid using
a high pressure cleaner for the cleaning.
The gearbox on the cultivator is from the factory
lubricated with 0.2 litre TEXACO Multifak 283
EPOO oil. It is not necessary to renew the oil
6