Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLING THE UNIT (continued)
Fig. 5
Fig. 6
Fig. 7
Step 6:
lower chimney to the range hood as shown in Figure 5
Step 7:
To avoid scratching the chimney, extend the upper
chimney slowly and carefully to the chimney-mounting
bracket and tighten screws as shown in Figure
NOTE:
Remove
chimney cover and the hood.
Step 8:
Insert
:
Step 9
To install the filters, refer to Figure 8 by following the steps
Fig. 8
below:
1. Point the filter toward the rear of the hood.
2. Push the filter until it is level.
3. Slide forward in the check mark on the front of the
4. Lower the filter.
5. Slide back until it snaps into place.
:
Step 10
Turn power ON in control panel. Check all lights and fan
functions.
Install both chimneys and tighten screws to secure the
the protective plastic film covering the top
the oil tunnel (see figure 7).
hood.
25
.
6.
Publicité
Chapitres
Table des Matières
