Flex L 26-6 230 Notice D'instruction D'origine page 16

Safety Warnings for Angle Grinder
WARNING!
Read all safety warnings and all instruc-
tions. Failure to follow the warnings and
instructions may result in electric shock, fire
and/or serious injury. Save all warnings and
instructions for future reference.
Safety Warnings Common for Grinding,
Sanding or Abrasive Cutting-Off
Operations
This power tool is intended to function as

a grinder, sander or cut-off tool. Read all
safety warnings, in-structions, illustrations
and specifications provided with this
power tool. Failure to follow all instructions
listed below may result in electric shock,
fire and/or serious injury.
Operations such as wire brushing or

polishing are not recommended to be
performed with this power tool.
Operations for which the power tool was
not designed may create a hazard and
cause personal injury.
Do not use accessories which are not

specifically designed and recommended
by the tool manufacturer. Just because the
accessory can be attached to your power
tool, it does not assure safe operation.
The rated speed of the accessory must be

at least equal to the maximum speed
marked on the power tool. Accessories
running faster than their rated speed can
break and fly apart.
The outside diameter and the thickness of

your accessory must be within the
capacity rating of your power tool.
Incorrectly sized accessories cannot be
adequately guarded or controlled.
Threaded mounting of accessories must

match the grinder spindle thread. For
accessories mounted by flanges, the
arbour hole of the accessory must fit the
locating diameter of the flange.
Accessories that do not match the
mounting hardware of the power tool will
run out of balance, vibrate excessively and
may cause loss of control.
16
Do not use a damaged accessory. Before

each use inspect the accessory such as
abrasive wheels for chips and cracks,
backing pad for cracks, tear or excess
wear, wire brush for loose or cracked
wires. If power tool or accessory is
dropped, inspect for damage or install an
undamaged accessory. After inspecting
and installing an accessory, position
yourself and bystanders away from the
plane of the rotating accessory and run the
power tool at maximum no-load speed for
one minute. Damaged accessories will
normally break apart during this test time.
Wear personal protective equipment.

Depending on application, use face shield,
safety goggles or safety glasses. As
appropriate, wear dust mask, hearing
protectors, gloves and workshop apron
capable of stopping small abrasive or
workpiece fragments. The eye protection
must be capable of stopping flying debris
generated by various operations. The dust
mask or respirator must be capable of
filtrating particles generated by your
operation. Prolonged exposure to high
intensity noise may cause hearing loss.
Keep bystanders a safe distance away

from work area. Anyone entering the work
area must wear personal protective
equipment. Fragments of workpiece or of
a broken accessory may fly away and
cause injury beyond immediate area of
operation.
Hold the power tool by insulated gripping

surfaces only, when performing an
operation where the cutting accessory
may contact hidden wiring or its own cord.
Cutting accessory contacting a "live" wire
may make exposed metal parts of the
power tool "live" and could give the
operator an electric shock.
Position the cord clear of the spinning

accessory. If you lose control, the cord
may be cut or snagged and your hand or
arm may be pulled into the spinning
accessory.
Never lay the power tool down until the

accessory has come to a complete stop.
The spinning accessory may grab the
surface and pull the power tool out of your
control.
L 26-6 230