Flex L 26-6 230 Notice D'instruction D'origine page 22

Screw the clamping nut with flange face

up, onto the spindle.
Press and hold down the spindle lock.

Tighten the clamping nut with the face

spanner.
Carry out a test run to check that the tool

is clamped in the centre.
Attaching the Velcro pad
Remove the guard.

Press and hold down the spindle lock (1.).

Using the face spanner, loosen the

clamping nut on the spindle in an anti-
clockwise direction and remove.
Remove clamping flange.

Screw Velcro pad clockwise onto the

spindle and tighten hand-tight (2.).
Place the sanding tool in the centre of the

Velcro pad and press on.
Carry out a test run to check that the tool

is clamped in the centre.
Test run
Insert the mains plug into the socket.

Switch on the angle grinder with the

switch (without engaging it) and run the
angle grinder for approx. 30 seconds.
Check for imbalances and vibrations.
Switch off the angle grinder.

22
Switching on and off
Brief operation without engaged switch
Press and hold down the starting

lockout (1.).
Press the switch (2.).

To switch off, release the switch.

Continuous operation with engaged
switch
Press and hold down the starting

lockout (1.).
Press and hold down the switch (2.).

Press the locking button (3.).

To switch off, briefly press and release

the switch.
NOTE
Following a power failure, the switched on
power tool does not restart.
L 26-6 230