Carbon Filter; Lighting - Atag WS60211IM Mode D'emploi

MAINTENANCE
Grease filters

Carbon filter

Lighting

Removing the grease filters
1. Switch off the motor and lighting.
2. Remove the grease filters from the hood by pulling the
special handle.
Replacing the carbon filter
1. The grease filters should first be removed before replacing the
carbon filter.
2. Slot the notches of the carbon filter in the specially
designed opening.
Note!
• The carbon filter must always be used if the cooker hood does not
have an outlet.
• Using a carbon filter creates more sound than when using the
cooker hood with an outlet.
• The carbon filter's operation is optimal at a lower motor speed.
You should, therefore, avoid using the boost function.
• Saturation of the carbon filter will eventually occur after more or
less prolonged use, depending on the type of cooking and how
frequently the grease filter is cleaned.
• It is necessary to replace the carbon filter when indicated by the
filter indicator.
• Do not wash or reuse the carbon filter. Saturated carbon is not
environmentally friendly.
Attention!
This hood is fitted with LED light! These have to be replaced by an
authorized technician. Do not attempt to replace LED light by yourself.
The lamp in this household appliance is only suitable for
illumination of this appliance. The lamp is not suitable for
household room illumination.
EN 9