Minimum Installation Dimensions; Measuring The Chassis Height; Determining The Installation Type; Special Accessory Installation - Truma Mover SR Instructions De Montage Et Mode D'emploi

Minimum installation dimensions

A distinction is made between L-profiled and U-profiled
chassis as shown in the illustration.
Caravan floor
L-profile
Fig. 5
The equipment can only be fitted to caravans / trailers within
the following dimensions.
Caravan floor
170
min. 25
min. 35 **
min. 50
min. 1200 / max. 2000
max. 2400
Fig. 6
All dimensions in mm.
* for a loaded vehicle with a max. allowed gross weight
** for U-profile

Measuring the chassis height

A frame height of min. 170 mm is required about 330 mm
from the outer edge of the tyre at the height of the wheel
hub / centre.
Fig. 7

Determining the installation type

1. Standard installation
Standard installation for chassis with a U or L-profile and a
frame height of min. 170 mm. No special accessories are
required.
2. Installation in a chassis with a U or L-profile and
frame height between 110 mm and less than 170 mm
The spacer set 30 mm (up to 140 mm frame height) or spacer
set 60 mm (less than 140 mm frame height) is required to
compensate the height difference.
3. Installation with chassis with U-profiles or L-profiles
with frame height of less than 110 mm
A low chassis kit needs to be used to compensate the
height difference for chassis with a height of less than 110 mm.
In Germany, the low chassis kit installation must
be accepted by a vehicle expert.
4. The AL-KO Vario III / AV installation kit must be used
with the AL-KO Vario III / AV chassis with a frame thickness of
less than 2.8 mm.
4a. For mounting in front of the axle on the
AL-KO Chassis M, with sliding rails
The AL-KO Chassis M Adapter set needs to be used to
compensate the overlapping frame edges.
18
U-profile
min. 170
330
5. Installation with Eriba Touring chassis
The Eriba Touring mounting set is needed for the Eriba Tour-
ing chassis.

Special accessory installation

1. Spacer set 30 mm
For compensating the height difference for caravans / trailers
with a frame height of less than 170 mm and up to140 mm,
part no. 60030-95000.
Fig. 8
2. Spacer set 60 mm
For compensating the height difference for caravans / trailers
with a frame height of less than 140 mm and up to 110 mm,
part no. 60030-95100.
Fig. 9
3. Low chassis kit
For compensating the height difference for caravans / trailers
with a frame height of less than 110 mm and / or for bridging
struts,
part no. 60010-64900.
Fig. 10
In Germany, this installationkit must be accepted by
a vehicle expert.
4. Low chassis kit, short
For compensating the height difference for caravans / trailers
with a frame height of less than 110 mm,
part no. 60030-37600.
Fig. 11
In Germany, this installation kit must be accepted by
a vehicle expert.