Symbols Used; Safety Instructions; General Instructions - Truma Mover SR Instructions De Montage Et Mode D'emploi

Mover® SR Version 2
Table of contents

Symbols used ...................................................................... 13

Safety instructions .......................................................... 13

General instructions ........................................................ 13

Batteries ............................................................................ 14
Function description ....................................................... 14
Operating instructions
Remote Handset ................................................................. 14
Remote hand set LED flash codes and acoustic signal ...... 14
Changing the batteries in the remote handset .................. 15
Manoeuvring the Caravan .............................................. 15
Hitching to a tow car ....................................................... 15
Maintenance ..................................................................... 15
Checks ................................................................................. 15
Trouble-shooting .............................................................. 15
Synchronising the electronic control unit with the
radio remote hand set ......................................................... 16
Conformity Declaration .................................................. 16
Technical data ................................................................... 16
Manufacturer's terms of warranty ............................... 17
Installation instructions
Intended use ........................................................................ 17
Approval .............................................................................. 17
Tools and facilities required ................................................ 17
Minimum installation dimensions ....................................... 18
Measuring the chassis height ............................................. 18
Determining the installation type ........................................ 18
Special accessory installation ............................................. 18
Choice of location .............................................................. 19
Installation of the drive units ......................................... 19
Installing the cross actuation device .................................. 21
Installation of motor cables and control unit ............. 21
Connecting diagram ............................................................ 21
Connecting the drive motors .............................................. 22
Connecting the battery ....................................................... 22
Commissioning the Mover® .......................................... 22
Warning information ........................................................... 22
Symbols used
Symbol indicates a possible hazard.
Comment including information and tips.
Safety instructions
- Practice operating the Mover® in an open area before using
for the first time. This to fully familiarise yourself with
the handset / Mover® operation.
- Always check tyres and drive rollers before using the equip-
ment; remove sharp-edged stones and the like if necessary.
- No person must be present in the caravan during operation.
- All persons (particularly children) must remain outside
the Mover® operating area.
- When operating the Mover®, ensure that no hairs, fingers
or other body parts, clothing or any other objects carried on
the body can become trapped by moving or rotating parts
(e.g. drive rollers).
- The distance between the radio remote hand set and
the centre of the caravan when manoeuvring must not
exceed 10 m!
- In the event of malfunctions pull on the handbrake.
- To prevent the caravan from tipping, direct the tow hitch
downhill when manoeuvering down a slope.
- After manoeuvring, always apply the handbrake first, dis-
engage the drive rollers from the tyres and block the
wheels (particularly on downwards-sloping surfaces). The
Mover® is not suitable for use as a parking brake for a
parked caravan.
- Ensure that remote radio control is protected from unau-
thorised access (particularly by children!).
- Never tow the caravan with the drive rollers applied. This
can cause damage to the tyres, the towing vehicle and the
drive units.
- All wheels and tyres on the caravan must be of the same
size and design.
- In order to ensure that the Mover® operates correctly, the
distance between the tyres and the disengaged drive roll-
ers must be 20 mm. All tyres must have the same inflation
pressure as per the manufacturer's instructions (check at
regular intervals!). If tyres are worn or new tyres are fitted,
the distance between the drive rollers and the tyres may
need readjusting (see "Installation of the drive units").
- Do not use the Mover® as a support when jacking up the
caravan, since this can damage the drive unit.
- Sensitive objects such as cameras, DVD-Players etc. must
not be kept in the stowage box near the control unit or the
motor cable. They can be damaged by the electromagnetic
fields.
- The empty weight of the vehicle increases by the weight of
the Mover®, which reduces the payload of the vehicle.
- When engaging, ensure that there are no objects (e.g.
stones, blocks of ice) between the engine and the motor
frame.
General instructions
The Mover® SR was developed to overcome pitches of up to
13 % for a total weight of 2000 kg on suitable ground.
Depending on the weight of the caravan, the Mover® cannot
overcome obstructions that are more than about 2 cm in
height without assistance (please use wedges as a ramp).
Due to the nature of a radio signal, it can get corrupted by ex-
ternal terrain or objects. So there may be small areas around
the caravan where the quality of reception reduces, hence the
Mover® may stop momentarily.
When the Mover® is switched off using the remote
control the control unit remains in standby. In order to
switch off completely the battery must be disconnected or
an isolating switch installed.
13